Does your work require you to stand, planted in one position for hours on end?
Any prolonged position can hurt your body, and standing is no exception. There
is no single, ideal body position for working. The best position is a variety
of positions, where you equally distribute loads on different parts of the body
but causes no physical strain. The reality in many workplaces, however, is that
workers often sit or stand for long periods of time.

Anyone whose job requires them to stand on their feet for hours on end
(salesperson, machine operator, assembly-line worker) can attest to the
physical discomforts they may experience. These may include: sore feet,
swelling of the legs, general muscular fatigue, low back pain, and stiffness in
the neck and shoulders. There are a variety of health problems that may be
caused by prolonged and frequent standing. Without some relief by walking,
blood may pool in the legs and feet. This can cause inflammation of the veins
that may progress over time to painful varicose veins. Excessive standing also
causes the joints in the spine, hips, knees and feet to become temporarily
immobilized or locked. This immobility can later lead to rheumatic diseases due
to degenerative damage to the tendons and ligaments.

If you spend most of your time at work standing, there are things you can do to
reduce the ill effects on your posture.

Workstation set up


Any stand-up workstation should be adjusted according to your height, using
elbow height as the guide. For example, precision work, such as writing or
electronic assembly, requires a work surface that's 5 cm above elbow height;
your elbows should be supported. Light work, such as assembly-line or
mechanical jobs, require a work surface that is 5 to 10 cm below elbow height.
Heavy work, demanding downward forces, requires a surface that is 20 to 40 cm
below elbow height.

Proper position


If you work in a standing position, always face what you're working on, keeping
your body close to the work. Adjust the workspace so that you have enough space
to change working position. Use a foot rail or portable footrest to shift your
body weight from both legs to one or the other leg. Use a seat whenever
possible while working, or at least during rest breaks. Avoid over-reaching
behind or above the shoulder line, or beyond the point of what is comfortable.
Instead of reaching, shift your feet to face the object.

If you must stand to work, take frequent rest breaks. Find ways to change
position as much as possible while you work.

Comfortable footwear


If your feet are not comfortable, nor are your legs, hips and back. The comfort
of your feet depends largely on your footwear. Choose CSA-approved footwear
with the proper ratings for the hazards in your workplace. Your shoes should be
as wide as your feet, leaving room to move your toes. They should have arch
supports to prevent flattening of the feet, and a heel with a firm grip to
prevent slipping. Lace-up shoes are best, because they allow you to tighten the
instep of your footwear, keeping your foot from slipping inside the shoe or
boot. The footwear should have heels that are not flat, but are no higher than
5 cm (2 inches). Wear padding under the tongue if you suffer from tenderness
over the bones at the top of the foot. And if you work on a metal or cement
floor, cushion your foot with a shock-absorbing insole.

Proper standing surface


The floor you stand on also greatly affects your level of comfort. Wooden, cork
or rubber-covered floors are far preferable to concrete or metal, but if you
must stand on hard floors, stand on mats. Floor mats should have slanted edges
to help prevent tripping. They must be dense enough to cushion the feet, but
not too thick. Too much cushioning, from thick foam-rubber mats, for example,
can cause fatigue and increase the hazard of tripping.

Remember that the ideal position is one that changes frequently.

Further Information:

AplusA-online.de - Source: Canadian Centre for Occupational Health and Safety